Roller through shot blasting machine is a common surface treatment equipment mainly used to clean the rust, oxide skin, and dirt on the surface of steel products, castings, and other workpieces, in order to improve the quality and roughness of the workpiece surface. During use, regular maintenance and repair are necessary to ensure the normal operation of the equipment and extend its service life. The following are the maintenance precautions for the roller through shot blasting machine.

    1. Regular inspection and maintenance: Before maintenance, it is necessary to first turn off the power supply and check whether the fasteners in various parts of the equipment are loose. If there is any looseness, it should be tightened in a timely manner. At the same time, check whether the electrical circuit is normal, whether the cables are damaged, and whether the lubrication condition of various parts of the body is good.

    2. Cleaning the inside of the equipment: During maintenance, it is necessary to clean the sand, dust, and debris in the shot blasting room, slag discharge tank, fan, and pipeline inside the equipment. Compressed air or a vacuum cleaner can be used for cleaning to ensure cleanliness inside the equipment.

    3. Inspection of shot blasting equipment: Check whether the shot blasting wheel, shot blasting chamber, and guide rail of the shot blasting machine are damaged or severely worn. If there are any problems, they should be replaced or repaired in a timely manner. At the same time, check whether the remaining amount of shot blasting in the shot blasting room meets the requirements, and inspect and maintain the lining plate of the shot blasting room.

    4. Check the transmission system of the equipment: Check whether the transmission chain, belt, transmission wheel, and other parts of the roller through shot blasting machine are worn or loose. If there are any problems, they should be replaced or adjusted in a timely manner. Simultaneously check the working status of the reducer and motor, and promptly repair any abnormalities.

    5. Check the filtration system of the equipment: The filtration system of the roller through shot blasting machine is the key to maintaining the equipment in good working condition. During maintenance, it is necessary to clean the filter, replace the damaged filter element, and ensure the cleanliness and recycling of the throwing agent.

    6. Check the equipment's inlet and outlet system: Check if the equipment's inlet and outlet system is smooth, and if there are any blockages, they should be cleaned in a timely manner. At the same time, check whether the sealing performance of the inlet and outlet devices is good. If any leakage is found, it should be repaired in a timely manner.

    7. Lubrication equipment: The transmission and friction parts of the roller table through shot blasting machine need to be regularly lubricated to reduce wear and friction, improve equipment efficiency and service life. Select suitable lubricants and lubricate according to the lubrication chart requirements.

    8. Regular calibration of equipment: During maintenance, it can assist in the calibration of equipment, such as checking the accuracy of sensors, switches, and instruments. If necessary, it can be calibrated or replaced.

    9. Safety inspection: During maintenance, it is necessary to inspect the safety protection devices of the equipment, such as thrust devices, circuit breakers, emergency stop devices, etc; Simultaneously check the accuracy of temperature, pressure and other instruments to ensure the safety performance of the equipment.

    10. Check the electrical system of the equipment: During maintenance, it is necessary to check the electrical system of the equipment, such as cables, wiring terminals, electrical components, etc., for damage or aging. If there are any problems, they should be replaced or repaired in a timely manner.

    In summary, regular maintenance and repair can maintain the good working condition of the roller through shot blasting machine, extend the service life of the equipment, and ensure the surface treatment effect of the workpiece.