How to install and use a roller through shot blasting machine?

The installation steps of the roller through shot blasting machine are as follows:

1. Installation of shot blasting cleaning machine for individual parts: from bottom to top.

2. Position of the shot blasting cleaning machine body: The levelness and weight of the body position must meet the requirements of the drawing.

3. The track type, suspension chain type, and roller pass type shot blasting cleaning machine should be installed from the inside of the equipment to the surrounding area.

4. During trial operation, partial trial operation should be carried out first, followed by normal operation.

Before installing this machine, the foundation should be made according to the foundation diagram, and the foundation should be horizontal without tilting or convexity. Anchor bolt holes and steel plates should be reserved, with accurate dimensions. After the installation of the entire machine is completed, adjust according to the main parameters of the equipment.

Adjustment of roller through shot blasting machine:

1. Adjust the shot control gate to achieve the required shot amount.

2. Adjust the air outlet gate to achieve dust removal effect.

3. When the elevator belt is loose, adjust the fastening screws to ensure that the belt is moderately tight.

4. Adjust the direction sleeve in the shot blaster, loosen the pressure block of the direction sleeve, rotate the direction sleeve back and forth, change the position of the direction sleeve window, and change the shot position.

If you want to carry out shot blasting, cleaning, and strengthen the roller through shot blasting machine equipment produced by Yancheng Dafeng Outstanding Machinery Co., Ltd., to ensure the shot blasting effect, high quality, and many years of production experience, manufacturers sell directly.