What safety hazards exist in the production process of roller pass shot blasting machines?

    Gas welding and cutting during the rolling process of the roller through shot blasting machine is a special task, so it is necessary to pay attention to safety, not only to the operators themselves, but also to others and surrounding facilities. The following editor summarizes the preventive measures for gas welding and gas cutting burn accidents during the production process of the roller table through shot blasting machine.

    1. Leakage of welding and cutting torch valves manufactured by shot blasting machines may cause burns. The regulating valves for welding and cutting torches must not leak. If the acetylene control valve leaks, the leaked acetylene will catch fire or form an explosive mixture, leading to an explosion. When the oxygen regulating valve leaks, oxygen enters the glove fibers and immediately burns when sparks are splashed. The gloves fall off and burn. Check the shot blasting machine welding gun, welding gun valve, and joints for leaks. If leakage is found, it should be repaired in a timely manner.

    2. Burns caused by tempering of the welding and cutting torches of the shot blasting machine. When the welding and cutting torches of the non suction shot blasting machine are backfired, the flame enters the acetylene pipe through the suction pipe, and oxygen and the back flame enter the acetylene pipe together. The backfire is very fast and difficult to discharge. If the acetylene pipe is burned out, it is easy to cause a burn accident. Therefore, the suction of the welding and cutting torches of the shot blasting machine should be checked before use. It is strictly prohibited to use the welding and cutting torches of the five shot suction shot blasting machine. The welding torch and acetylene pipe of the shot blasting machine should also be firm.

    3. Burns during the gas cutting process of the shot blasting machine. Direct cutting of metal materials may cause damage to cement. So protective measures should be taken, such as placing steel plates on cement floors. The gas cutting workpiece also needs to be raised by more than 100mm to prevent scalding caused by slag spraying. If the oxygen flow during the gas cutting of the shot blasting machine does not flow downwards, protective measures should be taken in the direction of the cutting oxygen flow to prevent a large number of splashes from injuring people and causing a fire.

    4.During the production process of the roller through shot blasting machine, it is necessary to strictly control the safety of on-site workers.

    5. The roller through shot blasting machine has a long working time, high work efficiency, and can process workpieces in batches. If there is rust or oxide layer on the surface of the workpiece, it can be placed in the shot blasting machine. Due to the fact that the roller table can continuously clean the workpiece through a shot blasting machine, the work efficiency is fast, the operation is very simple, and many processes are automatically completed. The entire operation process only requires a simple loop. Including the removal of oxide layer on the surface of the workpiece, dust removal, surface cleaning, etc.

    6. The roller table passes through the shot blasting machine to automatically clean the workpiece, greatly reducing the cost, especially the labor cost. In addition, the cleaning quality is good and will not damage the surface of the workpiece, which can make the workpiece look brand new. Even long-term rust can be removed. When the roller through shot blasting machine is working, there is a high-speed projectile bundle, which can remove stubborn oxide and rust layers due to strong impact friction.

    7. The roller through shot blasting machine has a dust removal device, so there is no need to worry about the accumulation and flight of falling impurities. With a dust removal device, it can effectively play a role in environmental protection while ensuring the normal operation of the machine. Excessive accumulation of dust can easily block the machine and pose a risk. In addition, it is important to pay attention to operational norms and avoid safety issues during work.