The roller through type shot blasting machine is basically composed of the following 10 accessories, and the detailed explanation is as follows:

1. Cleaning room

The cleaning room of the shot blasting machine is a large capacity plate box shaped assembly welding structure, and the cleaning operation is carried out in a sealed chamber.

2. Conveyor wheel track

It is divided into indoor conveying silver channel and loading and unloading section. The indoor jacket is equipped with a high chromium wear-resistant sheath and a limit ring. The high chromium wear-resistant sheath is used to protect the raceway and withstand any impact. The limit ring can make the workpiece run according to the predetermined position to prevent deviation and accidents.

3. Elevator

Mainly composed of upper and lower transmission, cylinder, belt, hopper, etc. The same diameter pulley on the elevator adopts ribbed plates, which are welded to the wheel hub into a polygonal structure to enhance friction, avoid slipping, and extend the service life of the belt. Bend the eggshell of the elevator into shape, open the cover plate on the shell of the elevator, repair and replace the hopper, and lap the belt. Opening the cover plate on the lower shell of the elevator can eliminate the blockage of the bottom bullet. Adjust the bolts on both sides of the upper shell of the elevator to drive the pull plate to move up and down, maintaining the tightness of the lifting belt. The upper and lower pulleys adopt square seat outer spherical ball bearings, which can automatically adjust when subjected to vibration and impact, and have good sealing performance.

4. Separators

The screw conveyor mainly consists of a reduction motor, a screw shaft, and a screw shell. Adopting a square seat outer spherical ball bearing, it can automatically adjust when the shaft is subjected to vibration and impact, and has good sealing performance.

5. Shot conveying tube

The shot conveying pipe has a dual shot control function, and a gate is set above each gate pipe to cut off the shot of the separator separately, making it easy to maintain their respective shot blasters; The opening size of the ram can adjust the projectile flow rate, and can also be combined according to the specifications of the cleaning workpiece to save energy, reduce machine wear, and ensure that production needs are met.

6. Shot blasting machine

Adopting a single disc shot blasting machine, it has become a high-level shot blasting machine in China. It mainly consists of a rotating mechanism, impeller, shell, directional sleeve, shot wheel, and guard plate. The impeller is made of Cr40 material, including forging, blades, directional sleeve, shot wheel, and guard plate.

7. Purging device

This device adopts a high-pressure fan, and multiple sets of elastic blowing nozzles with different angles are installed in the indoor auxiliary room to blow away the remaining projectiles on the surface of the workpiece.

8. Sealing of inlet and outlet

The sealing device for the inlet and outlet of the workpiece is made of rubber Zen spring steel plate. To prevent the shot from splashing out of the clean room during the shot blasting process, multiple reinforced sealing elements are installed at the inlet and outlet of the workpiece, which have the characteristics of strong elasticity, long service life, and good sealing effect.

9. Dust removal system

Bag filter mainly consists of bag filter, fan, dust removal pipe, etc. The dust removal efficiency can reach 99.5%. electric control

The system adopts conventional control to achieve full machine control, using high-quality electrical components produced domestically and internationally, which has the advantages of high reliability and easy maintenance. The main power circuit is protected by small circuit breakers and thermal relays for short circuit, phase loss, and overload. And multiple emergency stop switches are set to facilitate emergency shutdown and prevent accidents from expanding.